Rebug SwitchMe dev board for Nintendo Switch
Internal board to launch RCM payloads.
Cortex m0+ dev board
Board Dimensions 0.59 x 1.05 inch
Auto RCM Strapping – 5-6 wire install
Software Auto RCM – 4 wire install
Normal Mode – 4 wire install
Auto Payload injection after reboot – 5-6 wire install
If no Auto RCM Software or Strapping used you will either need to use a jig or solder pin 1-10 on the right joycon.
We will have detailed write-ups soon under the Nintendo Switch section of the site.
You can also use this as standalone development board (Like the Trinket m0)